Electronic pressure switch, type MP10 push-in, or with thread G1/8"

Order codes

PMP10P—  04  —   F3  —C

Output  04   PNP  02  NPN Connection  F3  G1/8" outer / M5 inner   R4  push-in Ø4  R6  push-in Ø6 Wiring    cable 3m  —C   3-pin connector M8x1

Technical data

Output 04 - PNP

Output 02 - NPN

Dimensions

Installation, setting

• When mounting, always use the wrench on the metallic area near the pressure port. Never apply a wrench to the plasticbody, it will damage the sensor
• Use the pressure setting trimmer to set „ON“ pressure. Rotate clockwise to increase pressure setpoint. Rotate counter-clockwise to decrease pressure setpoint